Windcave is setup with two options, sim and WIFI). Default is the sim, but you can switch to WIFI. This is how.
WIFI SETUP
Step 1: POS Config
- Reboot device by holding CLEAR and FUNC together while on the base. (If off the base, it will only shutdown; hit enter to boot up)
- When you see the Windcave logo, quick-press the CLEAR button once. Please note that this only appears for about 3 seconds, so you will need to be quick.
- When prompted to "Enter Menu Name", type "5210" and press ENTER.
- On the configurations screen, select POS Config.
- Select Connection Type.
- Select WIFI.
Step 2: Host Config
- Press CLEAR to take you back to the Configurations screen.
- Select Host Config.
- Select Network.
- WIFI- Select WIFI. (This should take you back to the Host Config screen)
Step 3: Connecting to WiFi
- Press CLEAR to take you back to the Configurations screen.
- Select HW CONFIG.
- When prompted to 'please insert a smart card' (white screen), press the MENU key (the grey circle button, next to the #3 key).
- Select Control Panel.
- Select Terminal Settings.
- Select Communication Means.
- Select WiFi.
- If not enabled, select the Enable option. If this option is not showing (and instead shows Switch Off), proceed to the next step.
- Select Scan Networks.
- When prompted, select your WiFi network name from the available networks. (Select Other if you want to specify the SSID/Network name you would like to connect to)
- When prompted, type in your WiFi password. Then press ENTER.
- Reboot the terminal by holding CLEAR and FUNC.
Your terminal will reboot and attempt to connect to the WiFi network. A Logon can be performed to test network connectivity.